Digicom 8D5684QB Betriebsanweisung PDF herunterladen (Seite 21)

3.7

Pocket AL I/O QB Conﬁguration

3.4.1. SMS Alarm Messages

The message sent by the device in case of alarm to the devices set during the conﬁguration will contain the following

information:

• PocketALI/OQBID(i.e.HOME)

• Contactnumber(i.e.1)

• ContactID(i.e.GasAlarm)

• Status

ON (alarm condition)

OFF (standard operating condition)

Examples

Contact 1 alarm

HOME

1)GasAlarm ON

Contact 1 alarm off

HOME

1)GasAlarm OFF

3.5. ANALOG INPUTS CONFIGURATION

Pocket AL I/O QB can read the values of two analog inputs where it is possible to connect analog sensors that operate with

4-20mA power.

To each single contact you can associate an input mnemonic name, 2 threshold values that can deﬁne 3 or 2 zones and the

detection interval. Pocket AL I/O QB will monitor the analog input as set by the user. The messsage of treshold excedeed (and

consequently of zone change) referred to the previous detection must be always sent after the ﬁrst detected value exceeding the

treshold, that is in the new zone.

# KEY # ID # Level1 # Level2 # Detection Timer # USER 1 # USER n # USER 6 #

NAME VALUE DESCRIPTION

Key 13,14 Key of analog inputs: 13 e 14

ID A..Z,a..z, ID associated to the contact (20 characters maximum. “#” and space characters not

0..9 accepted in the ID ﬁeld)

Level1 0..1000 Lower level (0 = 4mA 1000 = 20mA)

Level2 0..1000 Higher level (0 = 4mA 1000 = 20mA)

Detection timer 1..999sec Detection interval

User n + 0..9 Phone numbers to which the alarm message must be sent (up to six phone numbers can be

inserted)

NOTES

1. If you want to add a number to an already set list, it will be necessery to insert all the numbers again.

2. Pocket AL I/O QB will continuously monitor the analog input with the timer set by the user: Detection

timer.

3. You can set a single level by setting the value in Level1 and deﬁning Level2 at the maximum value:

1000

4. By setting the ﬁeld user1=”0” it will manage the input the status of which can be read with “test”

command, but no sms will be sent.

EXAMPLES

#13#Temperature#154#501#5#+393359988776#+393491122334#+393285554446#

#14#Waterlevel#258#409#1#+393359988776#+393491122334#+393285554446#

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

Digicom 8D5684QB Betriebsanweisung Seite 21

Kommentare zu diesen Handbüchern