Digicom SHDSL Bedienungsanleitung PDF herunterladen (Seite 29)

Chapter 4: Configuration

You can easily by checking the box next to the IP address to be blocked or allowed. Then, Add to insert to the

Ethernet Client Filter table. The maximum Ethernet client is 16.

Port Setting

This section allows you to configure the settings for the router’s Ethernet ports to solve some of the

compatibility problems that may be encountered while connecting to the Internet, as well allowing users to

tweak the performance of their network.

Port # Connection Type: Six options to choose from: Auto, 10M half-duplex, 10M full-duplex, 100M half-

duplex, 100M full-duplex and Disable. Sometimes, there are Ethernet compatibility problems with legacy

Ethernet devices, and you can configure different types to solve compatibility issues. The default is Auto,

which users should keep unless there are specific problems with PCs not being able to access your LAN.

IPv4 TOS priority Control (Advanced users): TOS, Type of Services, is the 2

octet of an IP packet. Bits 6-7

of this octet are reserved and bit 0-5 are used to specify the priority of the packet.

This feature uses bits 0-5 to classify the packet’s priority. If the packet is high priority, it will flow first and will not

be constrained by the Rate Limit. Therefore, when this feature is enabled, the router’s Ethernet switch will

check the 2

octet of each IP packet. If the value in the TOS field matches the checked values in the table (0

to 63), this packet will be treated as high priority.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 57 58

Keine Kommentare

Digicom SHDSL Bedienungsanleitung Seite 29